3.2.3. Digitizing detailed geometry

3.2.3.1. General

You can add a detailed geometry to waste water structures.

This is recommended for:

• Special structures and discharge points, because they are not normed structures like manholes, where you can define dimension1 and dimension2 to describe the extension.

• Infiltration installations where dimension1 and dimension2 are not enough to describe the geometry

Attention

Detailed geometry is usually not used for manholes or channels!

3.2.3.2. Digitizing tool

• Select the vw_qgep_wastewater_structure layer

• Select the object where you want to add a detailed geometry with the info tool

• Right click the object

• if there are several objects: select the vw_qgep_wastewater_structure layer

• Choose Digitize

• You can now start digitizing the polygon.

• Right click to stop.

An other way is to open the vw_qgep_wastewater_structure form with the info tool and then choose Digitize in the Actions menu of the form.

Note

If the geometry disappears after digitizing or if you get an message (like ‘Add part’), you have probably tried to digitize over a catchment area (or an other polygon theme) and the layer has set the avoid overlap option in the snapping settings. Do change the avoid overlap settings.